Buck Rogers K4ABT Manuale dell'Operatore Scaricare il pdf (Pagina 43)

The Packet Radio “2 N 1” Handbook by Buck Rogers K4ABT

Section 1; Packet Radio “The Basics” Section 2; The X1J4 System Node Operator’s (SNO) Handbook

Section II; TheNET X1J4 System Node Operators Handbook __ Page 43

NOTE: Many sysops set this parameter (#25) to 0 as a means to

reduce unnecessary node QRM on the frequency. The node sends

an ID's each time it sends a packet, so no legal requirement to have

ID's turned on.

As an example; In the MODES PARAMS, setting BEACON time to

600 will cause an ID by the X-IJ+ node every 10 minutes, or set it to

3600 and it will ID once each hour.

Parameter 26

CQ Broadcasts (1=0n, 0=off) (minimum=0,

maximum=1)

Defines whether or not the node will broadcast AX.25 UI-frames in

response to the CQ command. Even if such broadcasts are

disabled by setting this parameter to zero, the other features of the

CQ command continue to operate normally. The default value of 1

causes CQ broadcasts to be enabled.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 66 67

Nessun commento

Buck Rogers K4ABT Manuale dell'Operatore Pagina 43